====== boatyard ======
==== rudder (pre-engine removal) ====
  * verify tiller angle/sweep obstructions
    * test against proposed cockpit backrests
  * **measurements for tiller -> rudder attachment bracket design**
  * remove from boat

==== remove engine ====
  * remove from boat
  * crane
    * Danish Marine - 503-289-1436 
  * remove driveshaft, cutlass bearing
  * **remove/redesign skeg?**

==== rudder ====
  * verify/reshape to design profile if necessary
    * sand, surface & prep for paint
  * design/install windvane attachment points onto rudder

==== head ====
  * **cut in new door**
  * patch aft opening
  * **install head/nav station bulkhead**
  * prep head floor & shower pump
  * remove seacock, patch hull

==== propane locker ====
  * **design/construct deck surface hatch**
  * design/construct container
  
==== misc ====
  * demo existing depth transducer
    * confirm sizing for new transducer housing
  * **measure port hole spacing**
    * re-mark/cut for new spacing/symmetry

===== supplies =====
  * chain hoist, trolley, ibeam
  * crane
  * SS hardware for propane access hatch
    * McMaster order (Thurs 4/28)


====== shop/home ======
  * buy/setup bandsaw
  * new bandsaw outlet
    * same circuit as table saw - convert to 220V?
  * build frame (with hinges) for sewing machine
  * test water pump
  * test instruments
  * bottle opener on plate steel geometry?